Cobra 25-LTD Datenblatt PDF herunterladen (Seite 5)

Installation (Cont.)

Ignition Noise Interference

Use of a mobile receiver at low signal levels is normally limited by the presence

of electrical noise. The primary source of noise in automobile installations is from

the alternator and ignition system in the vehicle. Under most operating conditions,

when signal level is adequate, the background noise does not present a serious

problem. Also, when extremely low level signals are being received, the transceiver

may be operated with vehicle engine turned off. The unit requires very little

current and therefore will not significantly discharge the vehicle battery.

Even though the COBRA 25 LTD ST has an automatic noise limiter, in some instal-

lations ignition interference may be high enough to make good communications

impossible. The electrical noise may come from several sources. Many possibili-

ties exist and variations between vehicles require different solutions to reduce the

noise. Consult your COBRA dealer or a 2-way radio technician for help in locat-

ing and correcting the source of severe noise.

Base Station Operation (Operation from 120VAC, House Current)

To operate your transceiver from your home or office, using the regular house

current as the power source, you will require a 12 VDC power pack that has been

specially designed for the purpose. It is available as optional equipment from

your COBRA dealer. It consists of a 120-volt, 60 Hz AC to 12-volt DC power con-

verter that delivers the required power for the operation of the transceiver. Simply

connect the red (+) and black ( - ) leads of the transceiver to the corresponding

terminals of the power packs.

DO NOT ATTEMPT TO OPERATE THIS TRANSCEIVER BY

CONNECTING DIRECTLY TO 120 VAC.

Temporary Mobile Operation

To operate your COBRA transceiver from a car on a temporary basis, you may

want to purchase an optional cigar lighter adapter from your COBRA dealer. This

adapter and a magnetic mount antenna allow you to quickly "install" your trans-

ceiver for temporary use.

CB Antenna

Since the maximum allowable power output of the transmitter is limited by the

FCC, the antenna is one important factor affecting transmission distance. Only a

properly matched antenna system will allow maximum power transfer from the

50 ohm transmission line to the radiating element. In mobile installations (cars,

trucks, boats, etc.), an antenna system that is non-directional should be used.

A vertically polarized, quarter-wavelength whip antenna provides the most reli-

able operation and greatest range. Shorter, loaded-type whip antennas are more

attractive, compact and adequate for applications where the maximum possible

distance is not required. Also, the loaded whips do not present the problems of

height imposed by a full quarter-wavelength whip.

Mobile whip antennas utilize the metal body of the vehicle as a ground plane.

When mounted at a corner of the vehicle they are slightly directional, in the direc-

tion of the body of the vehicle. For all practical purposes, however, the radiation

pattern is nondirectional. The slight directional characteristic will be observed

only at extreme distances. A standard antenna connector (type SO-239) is provided

on the transceiver for easy connection to a standard PL 259 cable termination.

Cobra loaded type antenna models are highly recommended for most installa-

tions. Consult your Cobra dealer for further details, or call 773-889-3087 and

speak to a Cobra customer representative.

When installed in a boat, the transceiver will not operate at maximum efficiency

without a ground plate, unless the vessel has a steel hull. Before installing the trans-

ceiver in a boat, consult your dealer for information regarding an adequate ground-

ing system and prevention of electrolysis between fittings in the hull and water.

3-Way Combination Antennas are available which allow operation of all three

bands (AM-FM & CB), using a single antenna. However, use of this type of

antenna usually results in less than normal transmit and receive range when

compared to a standard-type "Single Band" antenna designed for CB only. The

quality of reception of radio signals is highly dependent on the antenna sys-

tem. Call 773-889-3087 for further information.

Installation (Cont.)

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare

Cobra 25-LTD Datenblatt Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Funkgeräte Cobra 25-LTD