Cobra C6 Spezifikationen PDF herunterladen (Seite 8)

The regulator connections are

” BSP female.

The connection to the appliance is

” BSP male.

(Refer to the 'Specifications' Section for the gas

supply location dimensions).

NOTE:

A Manual Isolation Valve must be fitted to the

individual appliance supply line.

4. Correctly locate the appliance into its final

operating position and using a spirit level, adjust

the legs so that the appliance is level and at the

correct height.

5. Connect the gas supply to the appliance. A

suitable joining compound which resists the

breakdown action of LPG must be used on

every gas line connection, unless compression

fittings are used.

6. Check all gas connections for leakages using

soapy water or other gas detecting equipment.

7. Check that the gas operating pressure is as

shown in ‘Specifications’ section.

NOTE:

The operating pressure to be measured at the

manifold test point and with 2 burners

operating at

the ‘High Flame’ setting.

8. Turn off the mains gas supply and bleed the gas

out of the appliance gas lines.

9. Turn 'On' the gas supply and the appliance.

10. Verify that the operating pressure remains

correct.

NOTE:

This appliance is fitted with adjustable feet to enable

the appliance to be positioned securely and level.

This should be carried out on completion of the gas

connection.

Part 3 Installation

Assembly

This model is delivered completely assembled.

Ensure that the legs and rollers are securely

attached.

NOTE:

This appliance is fitted with adjustable feet to enable

the appliance to be positioned securely and level.

This should be carried out on completion of the gas

connection. Refer to the 'Gas Connection' section.

Gas Connection

NOTE:

ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A

QUALIFIED SERVICE PERSON.

1. Cobra Series Ranges do not require an electrical

connection, they function totally on the gas

supply only.

2. It is essential that the gas supply is correct for the

appliance to be installed and that adequate

supply pressure and volume are available. The

following checks should therefore be made

before installation:-

a. The Gas Type the appliance has been

supplied for is shown on coloured stickers

located above the gas entry point and next

to the rating plate. Check that this is correct

for the gas supply the appliance is being

installed for. The gas conversion procedure is

detailed in the Gas Conversion Instruction

Sheet for this appliance.

b. Supply Pressure required for this appliance is

shown in the 'Specifications' section of this

manual. Check the gas supply to ensure that

adequate supply pressure exists.

c. Input Rate of this appliance is also stated on

the Rating Plate located on the front right

hand corner of the bottom sill and in the

'Specifications' section of this manual. The

input rate should be checked against the

available gas supply line capacity. Particular

note should be taken if the appliance is

being added to an existing installation.

NOTE:

It is important that adequately sized piping runs

directly to the connection joint on the appliance,

with as few tees and elbows as possible to give

maximum supply volume.

3. Fit the gas regulator supplied, into the gas supply

line as close to the appliance as possible.

NOTE:

The gas pressure regulator provided with this

appliance is convertible between Natural Gas and

LPG and is already converted ex-factory to the gas

type labelled beside the gas connection point. The

regulator outlet pressure is fixed ex-factory and it is

NOT to be adjusted.

WARNING:

DO NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

Cobra C6 Spezifikationen Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde Cobra C6