Cobra 2010 GTL WX Betriebsanleitung PDF herunterladen (Seite 21)

Section VI Appendix (Continued)

Fig. 4. Microphone plug pin numbers viewed from rear of pin receptacle.

Be sure that the housing and the knurled ring of Fig. 3 are pushed back onto the

microphone cable before starting to solder. If the washer is not captive to the pin

receptacle body, make sure that it is placed on the threaded portion of the pin

receptacle body before soldering.

If the microphone jack is used to hold the pin receptacle during soldering operation,

best results are obtained when the connections to pins 1 and 3 are made first and then

the connections to pins 2, 4 and 5. Use a minimum amount of solder and be careful

to prevent excessive solder accumulation on pins, which could cause a short between

the pin and the microphone plug housing.

6. When all soldering connections to the pins of the microphone are complete,

push the knurled ring and the housing forward and screw the housing onto the

threaded portion of the pin receptacle body. Note the location of the screw

clearance hole in the plug housing with respect to the threaded hole in the pin

receptacle body. When the housing is completely threaded into the pin

receptacle body, a final fraction of a turn either clockwise or counterclockwise

may be required to align the screw hole with the threaded hole in the pin

receptacle body. When these are aligned, the retaining screw is then screwed

into place to secure the housing to the pin receptacle body.

7. The two cable clamp retainer screws should now be tightened to secure the

housing to the microphone cord. If the cutting directions have been carefully

followed, the cable clamp should secure to the insulation jacket of the micro-

phone cable.

8. Upon completion of the microphone plug wiring, connect and secure the

microphone plug in the transceiver.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Cobra 2010 GTL WX Betriebsanleitung Seite 21