Cobra Colour Control 12 Bedienungsanleitung PDF herunterladen (Seite 13)

Playing a scene/chase by audio triggering

1.Select your scene/chase as described in the above section.

2.Press the audio button until its LED illuminates, indicating that audio mode is active.

3.Use the audio level fader to adjust the sensitivity.

4.To return to normal mode tap the audio button a second time, causing its LED to go out. Audio

mode is disengaged.

Notes:

This is the process for using the built-in microphone, or for using the audio input located on the rear

of the controller. This can be used for an alternative audio source for triggering the scenes/chases.

Fade time may also be used.

Playing a Scene/Chase Using The Speed Fader

1.Select a saved scene/chase.

2.Move the speed fader to the desired position (the top being the fastest).

3.Now you may move the speed fader to select your desired speed.

Notes:

Ensure audio mode is disengaged.

Fade time may also be used.

Change The Speed Mode Between 5 & 10 Minutes

1.Press & hold the record button.

2.Whilst holding down the record button, tap the flash button #5 or #10 three times.

3.The 5 min or 10 min LED should light, indicating the speed that the fader is set to run.

Midi in Mode

1.Press and hold the record button.

2.Press flash button 1, three times .

3.Release the record button.

4.The display shows 'CH-1' and the controller is in midi in mode.

5.Select the desired midi channel by pressing the respective flash button.

6.Hold down the record button and press record exit.

7.The midi channel has been memorized.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Keine Kommentare

Cobra Colour Control 12 Bedienungsanleitung Seite 13