7
Manual:
1. Press the Mode button until the LED in front of Manual lights up green.
2. With Tap Sync you can manually go through the chase steps.
Delete a chase:
1. Deselect all fixtures, scenes and chases.
2. Enter Record Mode by pressing the Record button for about 3 seconds.
3. Select the correct Page by pressing the Page button.
4. Press and hold the Tap Sync button. Now press the corresponding Chase button that you want to delete.
5. Exit Record Mode by pressing the Record button.
Add an Extra Step to an Existing Chase:
1. Enter Record Mode by pressing the Record button for about 3 seconds.
2. Select the Chase you want to add a step to.
3. Use the Mode/Up and Patch/Down buttons to scroll through the Chase. The display will show the current step.
4. Select the fixture you want to program by pressing the desired Fixture button.
5. Set the faders to the desired values.
6. Press the Record button to save a new step. All LEDs will flash 3 times, indicating your step has been
saved. The new step will be added after the selected one.
7. If you want to add additional steps repeat 4, 5 & 6, until you have added all the desired steps in your
entire chase.
8. Exit Record Mode by pressing the Record button for about 3 seconds.
**One Chase can contain a maximum of 1740 steps. 16 chases can contain a total maximum of 1740 steps**
Delete a Step from an Existing Chase:
1. Enter Record Mode by pressing the Record button.
2. Select the chase from which you want to delete a step.
3. Use the Mode/Up and Patch/Down buttons to scroll through the chase and select the step you want to
delete.
4. Push the Tap/Sync button to delete the step. All LEDs will flash 3 times, indicating the step has
successfully been deleted.
5. Continue this procedure (steps 2, 3 and 4) if you want to delete multiple steps. If you are finished
deleting the steps, press the Record button for about 3 seconds to exit Record Mode.
Advanced Settings:
Fixture channel sliders are patchable to different DMX addresses. They are also unpatchable to suit the
needs of the fixtures you are using. See below on how to carry these out:
Unpatch Channels:
1. Press and hold the Patch/Down button for 3 seconds. The Patch LED will light up red.
2. Deselect the fixture. No LEDs should be lit.
3. Use the Speed and Fade faders to select the DMX channel you want to unpatch.
4. Press the flash button corresponding to the channel name to unpatch the channel.
5. Hold Patch/Down button for 3 seconds to exit.
Example:
If you want to unpatch DMX address 17 on the red slider, fixture 03
1. Enter patch mode
2. Use the Speed and Fade sliders to find DMX address 17 and the display
will look like this picture
3. Then press the flash button Red
4. The display will now look like this:
5. Exit patch mode.
6. Now the red slider on fixture 3 will not send a DMX signal.
Patch DMX:017
Fixture03 Red
Patch DMX:017
No assign
Flash button
(19 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern