7
Entering Program Mode (Record Enable):
1. While holding the Record button, tap the Flash buttons #1-5-6-8 in sequence.
2. Release the Record button. The record LED lights up.
Exiting Program Mode:
1. Hold Record/Shift button. Whilst holding, press the Add Kill/Rec Exit button.
Create a Scene/Chase:
1. Record enable.
2. Select the 1-24 Single mode by tapping the Mode Select button. This will give you control of all 24
channels on the first page.
3. Compose a look by moving the faders (changes in fixture attribute such as colours & gobos, or simply
dimmer values).
4. Press Record to save the look in to the temporary memory.
5. Repeat steps 2-4 until you have your desired chase.
6. Do not repeat steps 2-4 if you are only saving a scene.
7. Select a scene master to store your scene. Tap the Page button to select a Page (1-4)
8. Press and hold the Record button and tap the Flash button for the scene that you wish to store it to. All
LEDs will flash indicating the scene has been programmed in to memory..
9. You can continue programming or exit. To exit programme mode, press and hold the Record button and
tap the Rec Exit button, the record LED will turn off.
Notes:
Deselect Blackout if LED is lit.
Be sure that you are on the right page by viewing the screen where it displays Page A or Page B. This will
enable 1-24 or 25-48 channel control.
If you just wish to create a static look, then you must create a scene composed of only 1 step.
There are 1000 steps available in every chase.
Edit Enable:
1. Record enable.
2. Use the Page button to select the page the program you wish to edit is on.
3. Tap the Mode Select buttons to select Chase <> Scenes.
4. Press and hold the Edit button and tap the Flash Button (13-24) of the scene/chase you wish to edit.
5. Release the Edit button. The relevant scene LED should light indicating you are in edit mode.
Notes:
When the edit mode is entered properly, the display will read editing.
This mode is displayed here for only the initiation of edit mode. Please see the following sections on the uses
of this mode in detail.
Delete a Step or Steps:
1. Enter the edit mode.
2. Tap the Step button to scroll to the step you wish to delete.
3. Tap the Delete/Rev One button when you reach the step you wish to delete. All the LEDs will light,
indicating the deletion of the step.
4. Repeat steps 2 & 3 until all of the unwanted steps have been deleted.
5. Press and hold the Record & Rec Exit Button. The scene button LED will turn off, indicating that the edit
mode has been exited.
Insert Step or Steps:
1. Record a scene you wish to insert (now your scene is stored in the edit buffer).
2. Be sure you are in Chase <> Scene and enter the edit mode.
(9 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern