8
3. Tap the Step button to scroll to the position of which you wish to insert your new step.
4. Tap the Insert button to insert the step you’ve created before.
5. Exit the edit mode.
Notes:
Part of entering the edit mode is selecting which scene you wish to edit. See selection on edit enable for
further instructions.
All LEDs will flash to indicate a successful insert of the step.
Modify a Step or Steps:
1. Enter the edit mode.
2. Tap the Step button to scroll to the step which you want to edit.
3. Whilst holding the Up or Down button, tap the Flash button corresponding to the DMX channel of the
scene you wish to modify until you reach the desired intensity value read from the display. Then you
may tap the Flash buttons until you are satisfied with the new Scene.
4. Repeat steps 2, 3 and 4 until all the steps have been modified.
5. Exit edit mode.
Notes:
Part of entering the edit mode is selecting which scene you wish to edit. See section on edit enable for further
instructions.
All LEDs will flash to indicate a successful insert of the step.
Erase a Scene or Chase:
1. Record enable.
2. Use the Page button to select the page that the scene you wish to erase is on.
3. Press and hold the Edit button and tap the Flash Button (13-24) of the Scene you wish to erase twice.
4. Release the 2 buttons. All LEDs should light indicating the program is erased.
Erase all Scenes/Chases:
1. Record enable.
2. Press and hold Record.
3. While holding the Record button, tap the Flash buttons in the following sequence #1-3-2-3. Release the
Record button.
4. All LEDs should light, indicating all programs have been erased.
5. Press and hold Record & Rec Exit to exit the mode.
Notes:
You must be in record mode to reset the controller.
The LED over the record button will light, indicating the record mode is in operation.
**Warning: This will reset the controller to its factory defaults. This will erase all programs and settings**
Record Clear:
1. Record enable.
2. Record a scene with one or more steps.
3. If you are not satisfied with the scene, you may press and hold the Record button and tap the Page
button. All LEDs will flash, indicating the scenes have been cleared.
Notes:
All the scenes stored in the temporary memory of the controller will be erased by this process.
This process will not affect the scenes already programmed in a scene fader.
Playback:
This controller uses the Channel Faders and Channel Flash buttons for multiple uses. In this instance, Channel
(9 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern