9
Faders 13-24 (37-48) are used for the playing back of Scenes/Chases already recorded. This is only when the
controller is in the Chase <> Scene mode. In this instance, Master Fader A will control the manual fader
controls, while Master Fader B will control the Scenes being played back.
Playing a Scene/ Chase:
1. Press the Mode Select button to select Chase <> Scene mode.
2. Press the Page button to select the correct page that the scene you wish to run is located.
3. Push the Master Fader B in to its maximum position (fully down).
4. Move the desired Channel fader (13-24) to its maximum, and the scene will fade in depending upon
current fade time.
5. Move the Channel fader to adjust the output of the current program.
Notes:
The current mode is indicated by the 3 LEDS:
Red is the Chase <> Scene.
Yellow is 2-scene pre-set A/B.
Green is 1-24 single mode.
You may press and hold down the relevant flash button for the scene to trigger to scene/chase momentarily.
Playing a Scene/Chase by Audiotriggering:
1. Select your scene/chase as described in the above section.
2. Press the Audio button until its LED lights, indicating the audio mode is active.
3. Use the Audio Level fader to adjust the sensitivity.
4. To return to normal mode tap the Audio button a second time causing its LED to go out. Audio mode is
disengaged.
Notes:
This is the process of using the built-in microphone, or using the audio jack located on the rear of the
controller to use an alternative audio source for triggering the scenes/chases.
Playing a Scene/Chase using the Speed Fader:
1. Select a saved scene/chase.
2. Move the Speed fader to the desired position (the top being the fastest).
3. Now you may move the Speed fader to select your desired speed.
Notes:
Be sure audio mode is disengaged.
Fade time can be used as well.
Change the Speed Mode Between 5 & 10 Minutes:
1. Press & hold the Record button.
2. Tap the Flash button #5 or #10 three times, whilst holding down the Record button.
3. The 5 min or 10 min LED should light, indicating the Speed the fader is set to run.
Physical Fader Assignment:
Use this feature to combine or unify fixture control attributes for different fixtures. For example; if you were
controlling 4 moving mirrors and 4 moving yokes, the colour, gobo and dimmer channels may not line up
ideally on the physical faders. Use this function to re-assign the dimmer, colour & gobo channels to faders 1,
2 & 3. From now on you will be able to control the same attributes on all fixtures using the same fade
location. This is also useful when needing to combine all colours together.
1. Press and hold the Record button.
2. While holding the record button, press the Flash button #6 three times.
3. Press the flash button that you wish to assign the DMX channel output to.
(9 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern